100% Updated EMC D-PE-FN-23 Enterprise PDF Dumps
Use Valid Exam D-PE-FN-23 by BootcampPDF Books For Free Website
NEW QUESTION # 133
Refer to the exhibit.
Which description matches the system displayed?
- A. Four HDD midplane in a Dell EMC PowerEdge server
- B. Four BOSS cards configured Dell EMC PowerEdge server
- C. Four-socket motherboard in a Dell EMC PowerEdge server
- D. Four-GPGPU configured Dell EMC PowerEdge server
Answer: C
NEW QUESTION # 134
What is an alternative configuration for a 40Gbps Ethernet connection?
- A. 1x 10 Gbps
- B. 4x 10 Gbps
- C. 10x 4 Gbps
- D. 1x 25 Gbps
Answer: B
NEW QUESTION # 135
An architect received the requirements for a low-budget development server. The applications on the server are not performance sensitive, but the customer would like some level of data protection.
Which storage solution fits these requirements?
- A. Software RAID 10
- B. Software RAID 5
- C. Hardware RAID 10
- D. Hardware RAID 5
Answer: B
NEW QUESTION # 136
An administrator has been tasked with installing a server with greater than 2TB partition.
Which boot mode would allow this?
- A. GRUB
- B. BIOS
- C. UEFI
- D. GUID
Answer: C
NEW QUESTION # 137
Where is a tower server commonly deployed, and why?
- A. Branch or remote location, because of security concerns
- B. Datacenter, because tower servers tend to be more powerful so more work can be done in the same physical space
- C. Datacenter, due to more PCI support allowing for more external storage
- D. Branch or remote location, because a rack is not needed
Answer: D
NEW QUESTION # 138
Which error control technique is used by ECC memory?
- A. Checksums
- B. Cryptographic hash functions
- C. Hamming code
- D. Repetition codes
Answer: C
NEW QUESTION # 139
An administrator needs to set up a RAID which requires high performance but no data protection.
Which RAID level fulfills these requirements?
- A. RAID 5
- B. RAID 1
- C. RAID 6
- D. RAID 0
Answer: D
NEW QUESTION # 140
A server administrator needs to change the settings of their iDRAC utilizing just the front panel.
Which configuration would allow this?
- A. LED Only
- B. LED with Quick Sync 2
- C. LCD Only
- D. Both LCD and LED
Answer: C
NEW QUESTION # 141
An administrator needs to know which IP address corresponds to a MAC address.
Which protocol will support this?
- A. DNS
- B. STP
- C. ARP
- D. DHCP
Answer: C
NEW QUESTION # 142
What is a benefit of having an Uninterruptible Power Supply (UPS) attached to a server?
- A. Provides permanent power to a server, eliminating the need for a wall outlet.
- B. Provides short-term protection to allow a server to be shut down gracefully.
- C. Keeps a server running during a long power outage
- D. Replaces the need for power supplies in a server.
Answer: B
NEW QUESTION # 143
An administrator wishes to create a large complex RAID set for a write intensive application that balances performance and cost.
Which complex RAID Level should be used?
- A. RAID 10
- B. RAID 5
- C. RAID 60
- D. RAID 50
Answer: D
NEW QUESTION # 144
What is the maximum amount of hard drives required per RAID set, when configuring RAID 50?
- A. 0
- B. 1
- C. 2
- D. 3
Answer: B
NEW QUESTION # 145
Where can an administrator view alerts in the iDRAC?
- A. Settings > Alerts
- B. Help > QR Code
- C. Quick Sync > QR Code
- D. Maintenance > System event log
Answer: D
NEW QUESTION # 146
A hospital wants to implement hardware security on one of their web servers.
Which implementation meets this requirement?
- A. DHCP service
- B. TPM
- C. Digital signing
- D. DNS role
Answer: B
NEW QUESTION # 147
Where can a history of change related to hardware components for a managed system be found?
- A. System Event Logs
- B. Lifecycle Logs
- C. Windows Event Logs
- D. Raid Controller Logs
Answer: B
NEW QUESTION # 148
A system administrator is configuring the file transfer role of a server. Important data needs to be accessed by end users.
Which file transfer service provides secure transfer of the data?
- A. SFTP
- B. TFTP
- C. FTP
- D. SNMP
Answer: A
NEW QUESTION # 149
Why is a mandatory practice to review the service manual prior to replacing or reseating components on a Dell EMC PowerEdge server?
- A. Service manual gives detailed instructions at which firmware levels the components should run
- B. Service manual provides vital information on which live wires in the system to avoid, to ensure electric shock does not occur
- C. Service manual covers crucial cable routing and special part handling instructions
- D. Service manual describes how to reconfigure the server for optional performance-boosting settings, increasing efficiency
Answer: C
NEW QUESTION # 150
A server administrator is deploying Windows 2022 Hyper-V. The virtual machines within the infrastructure will only be communicating with each other.
Which virtual switch must be configured to support this deployment?
- A. Distributed switch
- B. External switch
- C. Internal switch
- D. Private switch
Answer: D
NEW QUESTION # 151
How does Error Correcting Code (ECC) Memory function?
- A. ECC DIMMS work by adding 8 bits and extra chips to the system
- B. ECC DIMMS require an extra pair of DIMMS to be installed, to use for redundancy in case something fails
- C. ECC halts all processes until detected faults are resolved
- D. ECC installs firmware to mask errors, so the BIOS does not crash
Answer: A
NEW QUESTION # 152
A system administrator has Dell EMC PowerEdge server with dual 750W PSUs in a "Not Redundant" configuration with hot spare enabled. One PSU was accidentally removed from the server.
What is the expected behavior in this scenario?
- A. The server will immediately shutdown as PSUs were configured in "Not Redundant" mode
- B. If the active PSU was removed, the server will reboot to activate hot spare
- C. Available power remains unchanged as the output of two PSUs is never combined in servers
- D. Available power is reduced to a single PSU rated output, and the server may shutdown
Answer: D
NEW QUESTION # 153
Which type of cables are shown in the graphic?
- A. Copper
- B. Coaxial
- C. UTP
- D. Fibre
Answer: D
NEW QUESTION # 154
A backup administrator is migrating their tape drive backup solution from LTO-4 to LTO-6 generation.
Both LTO-3 and LTO-4 media are presently in use. All LTO-4 drives are to be replaced by LTO-6 drives, but the administrator plans to avoid replacing a maximum amount of the tapes already in use.
What should the administrator do to accomplish this task?
- A. Back up all critical data from LTO-3 tapes to LTO-4 tapes
Next, back up LTO-4 tapes to LTO-5 tapes - B. Back up all critical data from LTO-3 tapes to LTO-4 tapes
Next, back up LTO-4 tapes to LTO-5 tapes
Next, back up LTO-5 tapes to LTO-6 tapes - C. Back up all critical data on at least LTO-4 tapes in order to be read it from their new LTO-6 drives.
- D. Nothing, the administrator will still be able to read any tape currently in use will their LTO-6 drive and will be able to retrieve data if needed
Answer: C
NEW QUESTION # 155
Where can alerts on the LCD be viewed?
- A. Settings > Alerts
- B. Help > QR Code
- C. Quick Sync > QR Code
- D. Home Screen > Alerts
Answer: D
NEW QUESTION # 156
Which dual-level RAID configuration is combined to configure RAID 10 on a single array?
- A. RAID 1 RAID 0, parity and striped
- B. RAID 0 RAID 1, mirrored and striped
- C. RAID 0 RAID 1, striped and mirrored
- D. RAID 0 RAID 1, mirrored and parity
Answer: C
NEW QUESTION # 157
An MX7000 was purchased with minimal configuration.
What can an administrator add to make the MX7000 management interface fully redundant?
- A. Enterprise license
- B. MX9002m module
- C. MX9116n module
- D. CMC module
Answer: B
NEW QUESTION # 158
......
EMC D-PE-FN-23 Official Cert Guide PDF: https://www.bootcamppdf.com/D-PE-FN-23_exam-dumps.html